I2C PID Display Faceplate

A clear, acrylic face plate for your BrewTroller PID Display. This is laser cut from 3mm acrylic and is a great way to add some fit and finish to your control panel. Four 1/8" holes are aligned with the holes on the BTPD board.

Each face plate comes with 4 4-40 screws and 8 4-40 nuts. Put the face plate on the front of your control panel, put the screws through, nuts on the back to hold it in place, then a BTPD and another set of nuts behind the BTPD to hold it all together. 

The plate is 2.8" x 2.4" with rounded corners and four 1/8" mounting holes.

You can get the plate in either clear or smoked.